*2012/01/10 14:51:01.35 *IOS HEADER VERSION 1.10 2011/10/26 2011/10/26 *FILE START TIME : UTC 2011/07/28 11:30:00.000 TIME INCREMENT : 0 0 0 0.5 0 ! (day hr min sec ms) NUMBER OF RECORDS : 12 DATA DESCRIPTION : CTD FILE TYPE : ASCII CRC : C4289AB3 NUMBER OF CHANNELS : 5 $TABLE: CHANNELS ! No Name Units Minimum Maximum !--- --------------------------- --------------- -------------- -------------- 1 Pressure decibar 1.05 11.7 2 Temperature:Primary 'deg C (ITS90)' 10.09615 11.19351 3 Fluorescence:URU:Seapoint mg/m^3 1.5543 13.579 4 Salinity:T0:C0 PSS-78 26.42674 28.09604 5 Number_of_bin_records n/a 1 10 $END $TABLE: CHANNEL DETAIL ! No Pad Start Width Format Type Decimal_Places !--- ---- ----- ----- ------ ---- -------------- 1 -99 ' ' 7 F ' ' 1 2 -99 ' ' 9 F ' ' 4 3 -99 ' ' 8 F ' ' 3 4 -99 ' ' 9 F ' ' 4 5 ' ' ' ' 5 I I 0 $END $REMARKS This file converted from Sea-Bird file: P:\Cruise_Data_Processing\2011-59\Pro $END *ADMINISTRATION MISSION : 2011-59 AGENCY : IOS, Ocean Sciences Division, Sidney, B.C. COUNTRY : Canada PROJECT : Discovery Islands Circulation SCIENTIST : Tuele D. PLATFORM : Blackie *LOCATION GEOGRAPHIC AREA : Discovery Islands STATION : PA1 EVENT NUMBER : 4 LATITUDE : 50 31.68600 N ! (deg min) LONGITUDE : 125 22.15200 W ! (deg min) WATER DEPTH : 47 *INSTRUMENT TYPE : Sea-Bird CTD MODEL : SBE-19 SERIAL NUMBER : 1294 $REMARKS SOFTWARE VERSION 1.59 $END *HISTORY $TABLE: PROGRAMS ! Name Vers Date Time Recs In Recs Out ! -------- ------ ---------- -------- --------- --------- SBE_IOS 3.1 2012/01/10 11:18:53 1025 1025 HDREDIT2 2.5.1 2012/01/10 11:25:03 ? ? SHIFTDAT 3.4 2012/01/10 12:17:35 1025 1025 REVERSE 2.0 2012/01/10 12:18:43 1025 1025 DELETE 6.3 2012/01/10 13:22:37 1025 118 CTDEDIT 4.61 2012/01/10 13:40:19 118 113 CLEAN 5.0.4 2012/01/10 14:45:03 113 113 BINAVE 4.1.1 2012/01/10 14:45:10 113 12 REMOVECH 8.1.1 2012/01/10 14:45:15 12 12 HDREDIT2 2.5.1 2012/01/10 14:51:01 ? ? $END $REMARKS -HEADER EDITS: 2012/01/10 11:25:03 Applied edit header: P:\Cruise_Data_Processing\2011-59\Processing\doc\add long-lat-depth-stn.hdr Channel 2: Pressure:StrainGauge [decibar] Units: dbars ==> decibar -The following SHIFT parameters were used. Shift Channel: Conductivity:Primary # of Records to Advance (-ve for Delay): At REC# 0 Shift= -1.50 Salinity was recalculated after shift -The following DELETE parameters were used: Surface Record Removal: Last Press Min Maximum Surface Pressure (relative): 10.00 Surface Swell Pressure Tolerance: 1.00 Pressure NOT filtered. Swells deleted. Warning message if pressure difference of 2.00 Drop rates < 0.30m/s (calculated over 5 points) will be deleted. Drop rate applies in the range 10.00 to 1.94 dbars Sample interval (from FILE section of header) = 0.500 seconds. -CTDEDIT 2012/01/10 13:40:19 5 records were deleted in this editing session. No data values were changed. -CLEAN functions: 2012/01/10 14:45:03 20 Insert Pad Values in Channel: Fluorescence:Seapoint [mg/m^3] where channel Fluorescence:Seapoint [mg/m^3] is in the range 13.656 to 1000 21 data records in pad range. -The following BINAVE parameters were used: Bin channel = Pressure* Averaging interval = 1.00 Minimum bin value = 0.000 Average value was used Interpolated values were NOT used for empty bins Channel 'NUMBER_OF_BIN_RECORDS' was added to file. -REMOVECH 2012/01/10 14:45:15 The following CHANNEL(S) were removed: Scan_Number Conductivity:Primary [S/m] Descent_Rate [m/s] Flag -HEADER EDITS: 2012/01/10 14:51:01 Applied edit header: P:\Cruise_Data_Processing\2011-59\Processing\doc\2011-59-hdr.txt Channel 1: Pressure [decibar] Name: Pressure:StrainGauge ==> Pressure Channel 3: Fluorescence:URU:Seapoint [mg/m^3] Name: Fluorescence:Seapoint ==> Fluorescence:URU:Seapoint $END *COMMENTS SBE HEADER Sea-Bird SBE19 Data File: FileName = C:\Kyuquot\CTD Data\Feb2011\DiscoveryUV\July282011\28072011006.hex Software Version 1.59 Temperature SN = 1294 Conductivity SN = 1294 System UpLoad Time = Jul 29 2011 10:38:53 ds SEACAT PROFILER V3.0c SN 1294 07/29/11 10:41:45.410 strain gauge pressure sensor: SN = 163223, range = 1,000 psia, tc = -44 clk = 32768.039 iop = 158 vmain = 11.5 vlith = 5.5 mode = PROFILE ncasts = 11 sample rate = 1 scan every 0.5 seconds minimum raw conductivity frequency for pump turn on = 3335 hertz pump delay = 45 seconds samples = 26647 free = 31183 lwait = 0 msec SW1 = 90 battery cutoff = 7.2 volts number of voltages sampled = 2 logdata = NO S> dh cast 6 07/28 11:30:00 samples 18913 to 19937 sample rate = 1 scan every 0. 5 seconds stop = switch off S> # nquan = 8 # nvalues = 1025 # units = specified # name 0 = scan: Scan Count # name 1 = prSM: Pressure, Strain Gauge [db] # name 2 = t090C: Temperature [ITS-90, deg C] # name 3 = c0S/m: Conductivity [S/m] # name 4 = dz/dtM: Descent Rate [m/s] # name 5 = flSP: Fluorescence, Seapoint # name 6 = sal00: Salinity, Practical [PSU] # name 7 = flag: flag # span 0 = 1, 1025 # span 1 = -0.215, 11.939 # span 2 = 10.0924, 13.3797 # span 3 = 0.008126, 3.133690 # span 4 = -0.268, 0.357 # span 5 = 0.0000e+00, 1.3663e+01 # span 6 = 0.0512, 28.1046 # span 7 = 0.0000e+00, 0.0000e+00 # interval = seconds: 0.5 # start_time = Jul 28 2011 11:30:00 [Instrument's time stamp, header] # bad_flag = -9.990e-29 # # # # # 1294 # 01-Apr-08 # 1 # 0.00000000e+000 # 0.00000000e+000 # 0.00000000e+000 # 0.00000000e+000 # 0.000 # 4.23654454e-003 # 5.97243614e-004 # 3.49970925e-006 # -2.00770183e-006 # 1000.000 # 1.00000000 # 0.0000 # # # # # # 1294 # 01-Apr-08 # 1 # # 0.0000 # 2000.0000 # 0 # # 0.00000000e+000 # 0.00000000e+000 # 0.00000000e+000 # 0.00000000e+000 # 0.0 # 0.00000000e+000 # # # -3.89502607e+000 # 4.63087131e-001 # 1.94591096e-003 # -7.84053892e-005 # -9.57000000e-008 # 3.2500e-006 # # 0.00000000e+000 # # 1.00000000 # 0.00000 # # # # # # # # # 1 # 0.000 # # # # # # # # # 163223 # 02-Apr-08 # 4.961971e+002 # -1.302448e-001 # 1.274836e-007 # 0.00000 # # # # datcnv_date = Jan 10 2012 09:12:31, 7.21d [datcnv_vars = 6] # datcnv_in = P:\Cruise_Data_Processing\2011-59\RAW\CTD\28072011006.hex P:\Cruis e_Data_Processing\2011-59\RAW\CTD\1294 w-flu June 2011.xmlcon # datcnv_skipover = 0 # filter_date = Jan 10 2012 11:02:44, 7.21d # filter_in = P:\Cruise_Data_Processing\2011-59\Processing\convert\2011-59-0004. cnv # filter_low_pass_tc_A = 0.500 # filter_low_pass_tc_B = 2.000 # filter_low_pass_A_vars = c0S/m # filter_low_pass_B_vars = prSM # Derive_date = Jan 10 2012 11:07:32, 7.21d [derive_vars = 1] # Derive_in = P:\Cruise_Data_Processing\2011-59\Processing\filter\2011-59-0004.c nv P:\Cruise_Data_Processing\2011-59\Processing\doc\1294 w-flu June 2011.xmlcon # file_type = ascii END* CTDEDIT was used to remove a few surface records. Data Processing Notes: ---------------------- Fluorescence data are nominal and unedited except that some records were removed in editing temperature and salinity. Off-scale fluorescence values were replaced with PAD values. These data derive from the upcast section of the casts because the downcast data were corrupted by stops. For details on the processing see processing report: 2011-59-proc.doc. !--1--- ---2---- ---3--- ---4---- -5-- !Pressu Temperat Fluores Salinity Numb !re ure: cence: :T0:C0 er_o ! Primary URU: ~bin ! Seapoin _rec ! t ords !------ -------- ------- -------- ---- *END OF HEADER 1.0 11.1935 11.751 26.4267 6 2.0 10.5243 -99.000 27.6394 10 3.0 10.3596 13.579 27.7633 1 4.0 10.2672 10.891 27.8583 10 4.9 10.2318 5.656 27.9237 10 5.9 10.2139 2.566 27.9833 10 6.9 10.1550 1.998 28.0002 10 7.9 10.1278 2.132 28.0182 10 8.9 10.1084 2.281 28.0471 10 9.9 10.0989 1.884 28.0653 10 10.9 10.0961 1.554 28.0874 10 11.7 10.0995 1.730 28.0960 5