*2014/12/01 13:29:16.61 *IOS HEADER VERSION 1.10 2011/10/26 2011/10/26 *FILE START TIME : UTC 2002/07/30 23:19:30.000 TIME INCREMENT : 0 0 0 0.5 0 ! (day hr min sec ms) NUMBER OF RECORDS : 13 DATA DESCRIPTION : CTD FILE TYPE : ASCII CRC : FC31FA85 NUMBER OF CHANNELS : 4 $TABLE: CHANNELS ! No Name Units Minimum Maximum !--- ----------------------- --------------- -------------- -------------- 1 Pressure decibar 1.2437 12.51 2 Temperature:Primary 'deg C (ITS90)' 6.481 8.12199 3 Salinity:T0:C0 PSS-78 0.4825E-01 0.4864E-01 4 Number_of_bin_records n/a 1 17 $END $TABLE: CHANNEL DETAIL ! No Pad Start Width Format Type Decimal_Places !--- ---- ----- ----- ------ ---- -------------- 1 -99 ' ' 7 F ' ' 1 2 -99 ' ' 9 F ' ' 4 3 -99 ' ' 9 F ' ' 4 4 ' ' ' ' 5 I I 0 $END $REMARKS This file converted from Sea-Bird file: P:\Cruise_Data_Processing\2002-42\Pro $END *ADMINISTRATION MISSION : 2002-42 AGENCY : IOS, Ocean Sciences Division, Sidney, B.C. COUNTRY : Canada PROJECT : Quesnel Lake SCIENTIST : Carmack E. *LOCATION GEOGRAPHIC AREA : Quesnel Lake EVENT NUMBER : 4 LATITUDE : 52 29.58000 N ! (deg min) LONGITUDE : 121 24.36000 W ! (deg min) *INSTRUMENT TYPE : Sea-Bird CTD MODEL : SBE-19 SERIAL NUMBER : 2688 $TABLE: SENSORS ! Name Abs Depth Serial No ! ----------------------- -------------- ---------- Temperature ' ' 2688 Conductivity ' ' 2688 'Pressure:Strain Gauge' ' ' 192787 $END $REMARKS SOFTWARE VERSION 1.31 $END *HISTORY $TABLE: PROGRAMS ! Name Vers Date Time Recs In Recs Out ! -------- ------ ---------- -------- --------- --------- SBE_IOS 3.4.1 2014/11/29 15:52:19 518 518 CLEAN 5.2 2014/11/29 15:52:46 ? ? MERGEHDR 1.3 2014/11/29 15:55:57 518 518 ADTIMCH 4.4 2014/11/29 16:34:27 518 518 CLIP 1.3 2014/11/29 16:40:37 518 459 DELETE 6.3 2014/11/29 16:41:16 459 132 CTDEDIT 5.0.4 2014/12/01 12:40:35 132 97 BINAVE 4.2 2014/12/01 13:02:02 97 13 REMOVECH 8.2 2014/12/01 13:02:30 13 13 HDREDIT2 2.6 2014/12/01 13:29:16 ? ? $END $REMARKS -CLEAN functions: 2014/11/29 15:52:46 20 Set event to last 4 characters of file name -The following ADTIMCH parameters were used. Add 7.00 hours to times in header file section Change time zone to UTC in header file section -The following CLIP parameters were used. Clip by Record Number Limits First Record,Last Record = 60, 10000 Time Not Available in File -The following DELETE parameters were used: Surface Record Removal: Last Press Min Maximum Surface Pressure (relative): 10.00 Surface Swell Pressure Tolerance: 1.00 Pressure NOT filtered. Swells deleted. Warning message if pressure difference of 2.00 Drop rates < 0.20m/s (calculated over 5 points) will be deleted. Drop rate applies in the range 10.00 to 2.83 dbars Sample interval (from FILE section of header) = 0.500 seconds. -CTDEDIT v5.0.4 2014/12/01 12:40:35 35 records were deleted in this editing session. No data values were changed. -The following BINAVE parameters were used: Bin channel = Pressure* Averaging interval = 1.00 Minimum bin value = 0.000 Average value was used Interpolated values were NOT used for empty bins Channel 'NUMBER_OF_BIN_RECORDS' was added to file. -REMOVECH 2014/12/01 13:02:30 The following CHANNEL(S) were removed: Scan_Number Conductivity:Primary [S/m] Descent_Rate [m/s] Flag -HEADER EDITS: 2014/12/01 13:29:16 Applied edit header: P:\Cruise_Data_Processing\2002-42\Processing\doc\header.txt Channel 1: Pressure [decibar] Name: Pressure:StrainGauge ==> Pressure Format: F10.3 ==> F7.1 $END *COMMENTS SBE HEADER Sea-Bird SBE19 Data File: FileName = C:\2002-QLake\QL04.HEX Software Version 1.31 Temperature SN = 2688 Conductivity SN = 2688 System UpLoad Time = Jul 30 2002 16:32:10 ds SEACAT PROFILER V3.1b SN 2688 07/30/02 16:28:05.663 strain gauge pressure sensor: S/N = 192787, range = 1000 psia, tc = -70 Narrow Range Conductivity clk = 32767.594 iop = 173 vmain = 12.2 vlith = 5.1 mode = PROFILE ncasts = 4 sample rate = 1 scan every 0.5 seconds minimum raw conductivity frequency for pump turn on = 2718 hertz pump delay = 30 seconds samples = 3826 free = 170302 lwait = 0 msec SW1 = C8 battery cutoff = 7.3 volts number of voltages sampled = 0 logdata = NO S> dh cast 3 07/30 16:19:30 samples 3308 to 3825 sample rate = 1 scan every 0.5 seconds stop = switch off S> # nquan = 7 # nvalues = 518 # units = specified # name 0 = scan: Scan Count # name 1 = prSM: Pressure, Strain Gauge [db] # name 2 = t090C: Temperature [ITS-90, deg C] # name 3 = c0S/m: Conductivity [S/m] # name 4 = dz/dtM: Descent Rate [m/s] # name 5 = sal00: Salinity, Practical [PSU] # name 6 = flag: flag # span 0 = 1, 518 # span 1 = -0.326, 12.828 # span 2 = 6.4604, 9.5272 # span 3 = 0.006699, 0.007958 # span 4 = -0.713, 0.713 # span 5 = 0.0481, 0.0542 # span 6 = 0.0000e+00, 0.0000e+00 # interval = seconds: 0.5 # start_time = Jul 30 2002 16:19:30 [Instrument's time stamp, header] # bad_flag = -9.990e-29 # # # # # 2688 # 20-Feb-02 # 1 # 0.00000000e+000 # 0.00000000e+000 # 0.00000000e+000 # 0.00000000e+000 # 0.000 # 4.23493663e-003 # 6.10009842e-004 # 4.11611530e-006 # -2.20121499e-006 # 1000.000 # 1.00000000 # 0.0000 # # # # # # 2688 # 20 Feb 2002 # 1 # # 0.0000 # 2000.0000 # 0 # # 0.00000000e+000 # 0.00000000e+000 # 0.00000000e+000 # 0.00000000e+000 # 0.0 # 0.00000000e+000 # # # -4.23134446e+000 # 5.07012534e-001 # 3.90760974e-004 # 1.17602799e-005 # -9.57000000e-008 # 3.2500e-006 # # 0.00000000e+000 # # 1.00000000 # 0.00000 # # # # # # 192787 # 23-Feb-02 # 5.014606e+002 # -1.301456e-001 # 1.289662e-007 # 1.70000 # # # # datcnv_date = Nov 28 2014 17:03:07, 7.22.5 [datcnv_vars = 5] # datcnv_in = P:\Cruise_Data_Processing\2002-42\RAW\CTD\2002-42-0004.HEX P:\Crui se_Data_Processing\2002-42\Processing\doc\2002-42-ctd.xmlcon # datcnv_skipover = 0 # filter_date = Nov 29 2014 15:38:23, 7.22.5 # filter_in = P:\Cruise_Data_Processing\2002-42\Processing\convert\2002-42-0004. cnv # filter_low_pass_tc_A = 0.500 # filter_low_pass_tc_B = 2.000 # filter_low_pass_A_vars = c0S/m # filter_low_pass_B_vars = prSM # alignctd_date = Nov 29 2014 15:39:02, 7.22.5 # alignctd_in = P:\Cruise_Data_Processing\2002-42\Processing\filter\2002-42-0004 .cnv # alignctd_adv = t090C 0.500 # Derive_date = Nov 29 2014 15:50:01, 7.22.5 [derive_vars = 1] # Derive_in = P:\Cruise_Data_Processing\2002-42\Processing\align\2002-42-0004.cn v P:\Cruise_Data_Processing\2002-42\Processing\doc\2002-42-ctd.xmlcon # file_type = ascii END* Remarks from CTDEDIT: CTDEDIT was used to remove a records from the top and bottom of the cast. ********************************************************************** There was no salinity calibration sampling, but a post-cruise factory check indicates that there was no significant drift in conductivity or temperature calibration. ********************************************************************** !--1--- ---2---- ---3---- -4-- !Pressu Temperat Salinity Numb !re ure: :T0:C0 er_o ! Primary ~bin ! _rec ! ords !------ -------- -------- ---- *END OF HEADER 1.2 8.1220 0.0486 10 2.0 7.8699 0.0485 17 3.0 7.7263 0.0484 9 4.0 7.6436 0.0484 7 5.0 7.5752 0.0484 7 6.0 7.4955 0.0484 6 7.0 7.4442 0.0484 7 8.0 7.0249 0.0483 6 9.0 6.9592 0.0483 6 10.0 6.8969 0.0483 7 11.1 6.7793 0.0483 6 12.0 6.5747 0.0483 8 12.5 6.4810 0.0483 1