*2013/12/16 15:14:14.50 *IOS HEADER VERSION 1.10 2011/10/26 2011/10/26 *FILE START TIME : UTC 1998/07/26 21:59:52.000 TIME INCREMENT : 0 0 0 0.5 0 ! (day hr min sec ms) TIME ZERO : UTC 1970/01/01 00:00:00.000 NUMBER OF RECORDS : 49 DATA DESCRIPTION : CTD FILE TYPE : ASCII NUMBER OF CHANNELS : 4 $TABLE: CHANNELS ! No Name Units Minimum Maximum !--- ----------------------- --------------- -------------- -------------- 1 Pressure decibar 4 52 2 Temperature:Primary 'deg C (ITS90)' -1.7157 -1.436 3 Salinity PSS-78 31.0895 32.3429 4 Number_of_bin_records n/a 2 4 $END $TABLE: CHANNEL DETAIL ! No Pad Start Width Format Type Decimal_Places !--- ---- ----- ----- ------ ---- -------------- 1 -99 ' ' 7 F ' ' 1 2 -99 ' ' 9 F ' ' 4 3 -99 ' ' 9 F ' ' 4 4 -99 ' ' 5 I I 0 $END $REMARKS This file converted from Sea-Bird file: D:\9749\all\cnv1031\process\cnv\97490 $END *ADMINISTRATION MISSION : 1997-49 AGENCY : 'IOS, Marine Environment and Habitat Science,' CONTINUED : ' Sidney, B.C.' COUNTRY : Canada PROJECT : SHEBA Surface Heat Budget of the Arctic Ocean SCIENTIST : McLaughlin F. PLATFORM : Des Groseilliers *LOCATION GEOGRAPHIC AREA : Canada Basin, Northwind Ridge, Chukchi Plateau STATION : 67 EVENT NUMBER : 69 LATITUDE : 78 33.96000 N ! (deg min) LONGITUDE : 165 14.04000 W ! (deg min) WATER DEPTH : 693 *INSTRUMENT TYPE : Sea-Bird CTD MODEL : SBE-19 SERIAL NUMBER : 1031 $TABLE: SENSORS ! Name Abs Depth Serial No ! ---- -------------- ---------- ' ' ' ' ' ' $END $REMARKS SOFTWARE VERSION 4.224 $END *HISTORY $TABLE: PROGRAMS ! Name Vers Date Time Recs In Recs Out ! ------------------------ ------ ---------- -------- --------- --------- SBE_IOS 1.5 2000/07/24 12:15:26 164 164 DELETE 4.4 2000/07/24 12:18:47 163 163 CALIB 8.9 2000/07/24 12:31:06 163 163 CALIB 8.9 2000/07/24 12:34:39 163 163 CLIP 1.2 2000/07/24 12:43:37 163 154 REMOVECH 4.0 2000/07/24 16:45:39 154 154 DERIVEDQ 2.3 2000/07/24 16:46:53 154 154 CLIP 1.2 2000/07/24 17:19:14 154 154 BOXCAR 4.1 2000/07/24 17:33:44 154 154 BINAVE 3.0 2000/07/24 17:35:04 154 49 REMOVECH 6.0 2004/03/26 13:53:19 49 49 HDREDIT2 1.9 2004/03/26 13:59:48 ? ? CLEAN 4.5 2004/03/26 14:00:13 49 49 CHANGE_CTD_CHANNEL_NAMES 1.0 2013/12/16 15:14:14 49 49 $END $REMARKS -The following DELETE parameters were used: Surface Record Removal: OFF Pressure NOT filtered Swells deleted. Warning message if pressure difference of 2.00 Drop rates< 0.25m/s (calculated over 6 points) will be deleted Sample interval = 0.50 seconds. -The following CALIB parameters were used: Calibration type = Raw Mode: ONLY - calibration specs from Cal File only. Pressure offset = 0.0 Calibration file = D:\9749\all\cnv146\calcond.ccl Calibrations applied: Ch Name Units Fmla Coefficents -- ----------------------------- --------- --- ----------------------------- 3 Conductivity:Primary ratio 10 0.0000000E+00 0.2330242E+00 -The following CALIB parameters were used: Calibration type = Raw Mode: ONLY - calibration specs from Cal File only. Pressure offset = 0.0 Calibration file = D:\9749\all\cnv1031\cal1031.ccf Calibrations applied: Ch Name Units Fmla Coefficents -- ----------------------------- --------- --- ----------------------------- 3 Conductivity:Primary ratio 10 0.0000000E+00 0.1000287E+01 -The following CLIP parameters were used. Clip by Channel Range Clip Channel: Pressure Min,Max = 4.000, 4000.000 Time Not Available in File -The following CHANNEL(S) were removed from file. Flag -The following DERIVEQ parameters were used Reference channel for pressure is: Pressure Reference channel for temperature is: Temperature:Primary Reference channel for conductivity ratio is: Conductivity:Primary Reference channel for salinity is: Salinity Computed properties Derived Properties Ref Press Temp Type Replace ------------------ --------- --------- ------- Salinity Insitu Insitu YES -The following CLIP parameters were used. Clip by Record Number Limits First Record,Last Record = 1,154 Time Not Available in File -The following FILTER parameters were used. Boxcar filter was used. Filter width = 7 The following channel(s) were filtered. Salinity -The following BINAVE parameters were used: Bin channel = Pressure Averaging interval = 1.0 Minimum bin value = 0.000 Bin value was used Interpolated values were NOT used for empty bins Channel 'NUMBER_OF_BIN_RECORDS' was added to file. -The following CHANNEL(S) were removed from file. Conductivity:Primary CLEAN functions: - Reset #RECS, MIN & MAX values in header. - Change Pad Value to -99 in All Channels. - Delete Empty Channels: 0 deleted. $END *COMMENTS SBE HEADER Sea-Bird SBE 19 Data File: FileName = \SHEBA\SEASOFT\DATA\26jul.HEX Software Version 4.224 Temperature SN = 1031 Conductivity SN = 1031 System UpLoad Time = Jul 26 1998 12:50:21 Cruise: SHEBA Station: 67 Latitude: 78 33.96 N Longitude: 165 14.04 W Depth: 693 m (est) ds SEACAT PROFILER V3.0 SN 1031 07/26/98 22:10:47.419 strain gauge pressure sensor: S/N = 155452, range = 1000 psia, tc = 419 clk = 32767.500 iop = 183 vmain = 7.2 vlith = 5.6 mode = PROFILE ncasts = 2 sample rate = 1 scan every 0.5 seconds minimum raw conductivity frequency for pump turn on = 2926 hertz pump delay = 30 seconds samples = 582 free = 57248 lwait = 0 msec SW1 = 80 battery cutoff = 5.8 volts number of voltages sampled = 2 logdata = NO S> cast 1 07/26 21:59:52 samples 31 to 581 sample rate = 1 scan every 0.5 sec onds stop = switch off # nquan = 4 # nvalues = 164 # units = metric # name 0 = pr: pressure [db] # name 1 = t090: temperature, ITS-90 [deg C] # name 2 = c0S/m: conductivity [S/m] # name 3 = flag: 0.000e+00 # span 0 = 1.364, 52.662 # span 1 = -1.7162, -1.4344 # span 2 = 2.490347, 2.568904 # span 3 = 0.000e+00, 0.000e+00 # interval = seconds: 0.5 # start_time = Jul 26 98 21:59:52 # bad_flag = -9.990e-29 # sensor 0 = Frequency 0 temperature, 1031, 15may97s # sensor 1 = Frequency 1 conductivity, 1031W, 15may97s, cpcor = -9.5700e-08 # sensor 2 = Extrnl Volt 0 transmissometer, 109, 10dec97 # sensor 3 = Pressure Voltage, 155452, 15may97 # datcnv_date = Jun 30 2000 15:09:21, 4.244 # datcnv_in = 980726.HEX 1031-97.CON # datcnv_skipover = 0 # alignctd_date = Jul 24 2000 11:57:48, 4.244 # alignctd_in = 97490069.CNV # alignctd_cond_advSecs = 0.000, 0.000 # alignctd_temp_advSecs = 0.700, 0.000 # alignctd_oxygen_current_advSecs = 0.000, 0.000 # alignctd_oxygen_temp_advSecs = 0.000, 0.000 # alignctd_wetstar_advSecs = 0.000 # file_type = ascii END* *CALIBRATION $TABLE: RAW CHANNELS ! Name Units Fmla Pad Coefficients ! ---------------------- ------- ---- ------ ------------ Conductivity:Primary ratio 10 -9.99 (0 0.2330242) Conductivity:Primary ratio 10 -9.99 (0 1.000287) $END !--1--- ---2---- ---3---- -4-- !Pressu Temperat Salinity Numb !re ure: er_o ! Primary ~bin ! _rec ! ords !------ -------- -------- ---- *END OF HEADER 4.0 -1.4402 31.0895 2 5.0 -1.4386 31.1094 3 6.0 -1.4360 31.1302 3 7.0 -1.4365 31.1724 3 8.0 -1.4492 31.2390 4 9.0 -1.4541 31.2921 3 10.0 -1.4536 31.3394 3 11.0 -1.4577 31.3949 3 12.0 -1.4595 31.4416 3 13.0 -1.4702 31.5139 4 14.0 -1.4946 31.5937 3 15.0 -1.5016 31.6219 3 16.0 -1.5109 31.6376 4 17.0 -1.5271 31.6620 3 18.0 -1.5368 31.6860 3 19.0 -1.5462 31.7136 4 20.0 -1.5504 31.7370 3 21.0 -1.5551 31.7642 3 22.0 -1.5728 31.7973 3 23.0 -1.5859 31.8270 4 24.0 -1.5927 31.8487 3 25.0 -1.5980 31.8679 3 26.0 -1.6067 31.8935 3 27.0 -1.6204 31.9256 4 28.0 -1.6318 31.9512 3 29.0 -1.6389 31.9664 3 30.0 -1.6473 31.9772 3 31.0 -1.6517 31.9873 3 32.0 -1.6568 32.0013 3 33.0 -1.6650 32.0204 4 34.0 -1.6720 32.0403 3 35.0 -1.6762 32.0604 3 36.0 -1.6803 32.0832 3 37.0 -1.6841 32.1079 3 38.0 -1.6896 32.1345 3 39.0 -1.6976 32.1583 3 40.0 -1.6992 32.1779 3 41.0 -1.6984 32.1944 3 42.0 -1.7036 32.2086 3 43.0 -1.7006 32.2253 4 44.0 -1.6972 32.2411 2 45.0 -1.7006 32.2549 3 46.0 -1.7069 32.2700 3 47.0 -1.7132 32.2840 4 48.0 -1.7157 32.2981 3 49.0 -1.7096 32.3111 3 50.0 -1.7080 32.3221 3 51.0 -1.7134 32.3305 2 52.0 -1.7118 32.3429 4