*2013/12/16 15:14:14.29 *IOS HEADER VERSION 1.10 2011/10/26 2011/10/26 *FILE START TIME : UTC 1998/07/25 06:32:44.000 TIME INCREMENT : 0 0 0 0.5 0 ! (day hr min sec ms) TIME ZERO : UTC 1970/01/01 00:00:00.000 NUMBER OF RECORDS : 47 DATA DESCRIPTION : CTD FILE TYPE : ASCII NUMBER OF CHANNELS : 4 $TABLE: CHANNELS ! No Name Units Minimum Maximum !--- ----------------------- --------------- -------------- -------------- 1 Pressure decibar 4 50 2 Temperature:Primary 'deg C (ITS90)' -1.7006 -1.4384 3 Salinity PSS-78 29.4785 32.2808 4 Number_of_bin_records n/a 2 5 $END $TABLE: CHANNEL DETAIL ! No Pad Start Width Format Type Decimal_Places !--- ---- ----- ----- ------ ---- -------------- 1 -99 ' ' 7 F ' ' 1 2 -99 ' ' 9 F ' ' 4 3 -99 ' ' 9 F ' ' 4 4 -99 ' ' 5 I I 0 $END $REMARKS This file converted from Sea-Bird file: D:\9749\all\cnv1031\process\cnv\97490 $END *ADMINISTRATION MISSION : 1997-49 AGENCY : 'IOS, Marine Environment and Habitat Science,' CONTINUED : ' Sidney, B.C.' COUNTRY : Canada PROJECT : SHEBA Surface Heat Budget of the Arctic Ocean SCIENTIST : McLaughlin F. PLATFORM : Des Groseilliers *LOCATION GEOGRAPHIC AREA : Canada Basin, Northwind Ridge, Chukchi Plateau STATION : 65 EVENT NUMBER : 66 LATITUDE : 78 30.30000 N ! (deg min) LONGITUDE : 165 29.76000 W ! (deg min) WATER DEPTH : 614 *INSTRUMENT TYPE : Sea-Bird CTD MODEL : SBE-19 SERIAL NUMBER : 1031 $TABLE: SENSORS ! Name Abs Depth Serial No ! ---- -------------- ---------- ' ' ' ' ' ' $END $REMARKS SOFTWARE VERSION 4.224 $END *HISTORY $TABLE: PROGRAMS ! Name Vers Date Time Recs In Recs Out ! ------------------------ ------ ---------- -------- --------- --------- SBE_IOS 1.5 2000/07/24 12:15:22 177 177 DELETE 4.4 2000/07/24 12:18:43 176 176 CALIB 8.9 2000/07/24 12:31:03 176 176 CALIB 8.9 2000/07/24 12:34:37 176 176 CLIP 1.2 2000/07/24 12:43:36 176 159 REMOVECH 4.0 2000/07/24 16:45:37 159 159 DERIVEDQ 2.3 2000/07/24 16:46:49 159 159 CLIP 1.2 2000/07/24 17:19:10 159 159 BOXCAR 4.1 2000/07/24 17:33:42 159 159 BINAVE 3.0 2000/07/24 17:34:59 159 47 REMOVECH 6.0 2004/03/26 13:53:19 47 47 HDREDIT2 1.9 2004/03/26 13:59:47 ? ? CLEAN 4.5 2004/03/26 14:00:13 47 47 CHANGE_CTD_CHANNEL_NAMES 1.0 2013/12/16 15:14:14 47 47 $END $REMARKS -The following DELETE parameters were used: Surface Record Removal: OFF Pressure NOT filtered Swells deleted. Warning message if pressure difference of 2.00 Drop rates< 0.25m/s (calculated over 6 points) will be deleted Sample interval = 0.50 seconds. -The following CALIB parameters were used: Calibration type = Raw Mode: ONLY - calibration specs from Cal File only. Pressure offset = 0.0 Calibration file = D:\9749\all\cnv146\calcond.ccl Calibrations applied: Ch Name Units Fmla Coefficents -- ----------------------------- --------- --- ----------------------------- 3 Conductivity:Primary ratio 10 0.0000000E+00 0.2330242E+00 -The following CALIB parameters were used: Calibration type = Raw Mode: ONLY - calibration specs from Cal File only. Pressure offset = 0.0 Calibration file = D:\9749\all\cnv1031\cal1031.ccf Calibrations applied: Ch Name Units Fmla Coefficents -- ----------------------------- --------- --- ----------------------------- 3 Conductivity:Primary ratio 10 0.0000000E+00 0.1000287E+01 -The following CLIP parameters were used. Clip by Channel Range Clip Channel: Pressure Min,Max = 4.000, 4000.000 Time Not Available in File -The following CHANNEL(S) were removed from file. Flag -The following DERIVEQ parameters were used Reference channel for pressure is: Pressure Reference channel for temperature is: Temperature:Primary Reference channel for conductivity ratio is: Conductivity:Primary Reference channel for salinity is: Salinity Computed properties Derived Properties Ref Press Temp Type Replace ------------------ --------- --------- ------- Salinity Insitu Insitu YES -The following CLIP parameters were used. Clip by Record Number Limits First Record,Last Record = 1,159 Time Not Available in File -The following FILTER parameters were used. Boxcar filter was used. Filter width = 7 The following channel(s) were filtered. Salinity -The following BINAVE parameters were used: Bin channel = Pressure Averaging interval = 1.0 Minimum bin value = 0.000 Bin value was used Interpolated values were NOT used for empty bins Channel 'NUMBER_OF_BIN_RECORDS' was added to file. -The following CHANNEL(S) were removed from file. Conductivity:Primary CLEAN functions: - Reset #RECS, MIN & MAX values in header. - Change Pad Value to -99 in All Channels. - Delete Empty Channels: 0 deleted. $END *COMMENTS SBE HEADER Sea-Bird SBE 19 Data File: FileName = \SHEBA\SEASOFT\DATA\24jul.HEX Software Version 4.224 Temperature SN = 1031 Conductivity SN = 1031 System UpLoad Time = Jul 25 1998 09:32:49 Cruise: SHEBA Station: 65 Latitude: 78 30.30 N Longitude: 165 29.76 W Depth: 614 m (est) ds SEACAT PROFILER V3.0 SN 1031 07/25/98 18:53:25.391 strain gauge pressure sensor: S/N = 155452, range = 1000 psia, tc = 419 clk = 32767.594 iop = 182 vmain = 7.3 vlith = 5.6 mode = PROFILE ncasts = 1 sample rate = 1 scan every 0.5 seconds minimum raw conductivity frequency for pump turn on = 2926 hertz pump delay = 30 seconds samples = 433 free = 57397 lwait = 0 msec SW1 = 80 battery cutoff = 5.8 volts number of voltages sampled = 2 logdata = NO S> cast 0 07/25 06:32:44 samples 0 to 432 sample rate = 1 scan every 0.5 seco nds stop = switch off # nquan = 4 # nvalues = 177 # units = metric # name 0 = pr: pressure [db] # name 1 = t090: temperature, ITS-90 [deg C] # name 2 = c0S/m: conductivity [S/m] # name 3 = flag: 0.000e+00 # span 0 = 0.294, 50.341 # span 1 = -1.7021, 0.3748 # span 2 = 0.591339, 2.565838 # span 3 = 0.000e+00, 0.000e+00 # interval = seconds: 0.5 # start_time = Jul 25 98 06:32:44 # bad_flag = -9.990e-29 # sensor 0 = Frequency 0 temperature, 1031, 15may97s # sensor 1 = Frequency 1 conductivity, 1031W, 15may97s, cpcor = -9.5700e-08 # sensor 2 = Extrnl Volt 0 transmissometer, 109, 10dec97 # sensor 3 = Pressure Voltage, 155452, 15may97 # datcnv_date = Jun 30 2000 15:09:20, 4.244 # datcnv_in = 980725-1.HEX 1031-97.CON # datcnv_skipover = 0 # alignctd_date = Jul 24 2000 11:57:46, 4.244 # alignctd_in = 97490066.CNV # alignctd_cond_advSecs = 0.000, 0.000 # alignctd_temp_advSecs = 0.700, 0.000 # alignctd_oxygen_current_advSecs = 0.000, 0.000 # alignctd_oxygen_temp_advSecs = 0.000, 0.000 # alignctd_wetstar_advSecs = 0.000 # file_type = ascii END* *CALIBRATION $TABLE: RAW CHANNELS ! Name Units Fmla Pad Coefficients ! ---------------------- ------- ---- ------ ------------ Conductivity:Primary ratio 10 -9.99 (0 0.2330242) Conductivity:Primary ratio 10 -9.99 (0 1.000287) $END !--1--- ---2---- ---3---- -4-- !Pressu Temperat Salinity Numb !re ure: er_o ! Primary ~bin ! _rec ! ords !------ -------- -------- ---- *END OF HEADER 4.0 -1.4384 29.4785 2 5.0 -1.4481 29.9848 5 6.0 -1.4546 30.3801 4 7.0 -1.4577 30.7302 3 8.0 -1.4588 31.1231 4 9.0 -1.4526 31.3475 3 10.0 -1.4504 31.4364 3 11.0 -1.4550 31.4879 4 12.0 -1.4610 31.5216 3 13.0 -1.4679 31.5415 4 14.0 -1.4829 31.5669 3 15.0 -1.4952 31.5902 4 16.0 -1.5067 31.6158 3 17.0 -1.5252 31.6395 3 18.0 -1.5395 31.6557 4 19.0 -1.5438 31.6633 4 20.0 -1.5478 31.6720 3 21.0 -1.5564 31.6944 3 22.0 -1.5647 31.7301 3 23.0 -1.5680 31.7682 4 24.0 -1.5664 31.7963 3 25.0 -1.5623 31.8251 4 26.0 -1.5600 31.8530 3 27.0 -1.5633 31.8743 3 28.0 -1.5747 31.9044 4 29.0 -1.5920 31.9373 3 30.0 -1.5999 31.9553 3 31.0 -1.6070 31.9674 3 32.0 -1.6185 31.9821 4 33.0 -1.6317 31.9996 3 34.0 -1.6387 32.0124 3 35.0 -1.6444 32.0226 3 36.0 -1.6537 32.0365 4 37.0 -1.6615 32.0511 3 38.0 -1.6663 32.0631 3 39.0 -1.6732 32.0776 3 40.0 -1.6783 32.0946 3 41.0 -1.6775 32.1161 4 42.0 -1.6693 32.1382 3 43.0 -1.6736 32.1554 3 44.0 -1.6783 32.1760 4 45.0 -1.6771 32.1970 3 46.0 -1.6850 32.2129 3 47.0 -1.6938 32.2290 3 48.0 -1.6993 32.2466 4 49.0 -1.6999 32.2633 4 50.0 -1.7006 32.2808 4