*2013/12/16 15:14:12.96 *IOS HEADER VERSION 1.10 2011/10/26 2011/10/26 *FILE START TIME : UTC 1998/06/11 00:07:11.000 TIME INCREMENT : 0 0 0 0.5 0 ! (day hr min sec ms) TIME ZERO : UTC 1970/01/01 00:00:00.000 NUMBER OF RECORDS : 48 DATA DESCRIPTION : CTD FILE TYPE : ASCII NUMBER OF CHANNELS : 4 $TABLE: CHANNELS ! No Name Units Minimum Maximum !--- ----------------------- --------------- -------------- -------------- 1 Pressure decibar 4 51 2 Temperature:Primary 'deg C (ITS90)' -1.6525 -1.2005 3 Salinity PSS-78 31.2366 32.2288 4 Number_of_bin_records n/a 2 8 $END $TABLE: CHANNEL DETAIL ! No Pad Start Width Format Type Decimal_Places !--- ---- ----- ----- ------ ---- -------------- 1 -99 ' ' 7 F ' ' 1 2 -99 ' ' 9 F ' ' 4 3 -99 ' ' 9 F ' ' 4 4 -99 ' ' 5 I I 0 $END $REMARKS This file converted from Sea-Bird file: D:\9749\all\cnv1031\process\cnv\97490 $END *ADMINISTRATION MISSION : 1997-49 AGENCY : 'IOS, Marine Environment and Habitat Science,' CONTINUED : ' Sidney, B.C.' COUNTRY : Canada PROJECT : SHEBA Surface Heat Budget of the Arctic Ocean SCIENTIST : McLaughlin F. PLATFORM : Des Groseilliers *LOCATION GEOGRAPHIC AREA : Canada Basin, Northwind Ridge, Chukchi Plateau STATION : 45 EVENT NUMBER : 45 LATITUDE : 76 51.84000 N ! (deg min) LONGITUDE : 166 3.84000 W ! (deg min) WATER DEPTH : 1015 *INSTRUMENT TYPE : Sea-Bird CTD MODEL : SBE-19 SERIAL NUMBER : 1031 $TABLE: SENSORS ! Name Abs Depth Serial No ! ---- -------------- ---------- ' ' ' ' ' ' $END $REMARKS SOFTWARE VERSION 4.026 $END *HISTORY $TABLE: PROGRAMS ! Name Vers Date Time Recs In Recs Out ! ------------------------ ------ ---------- -------- --------- --------- SBE_IOS 1.5 2000/07/24 12:15:05 363 363 DELETE 4.4 2000/07/24 12:18:24 362 257 CALIB 8.9 2000/07/24 12:30:47 257 257 CALIB 8.9 2000/07/24 12:34:21 257 257 CLIP 1.2 2000/07/24 12:43:15 257 235 REMOVECH 4.0 2000/07/24 16:45:26 235 235 DERIVEDQ 2.3 2000/07/24 16:46:31 235 235 CLIP 1.2 2000/07/24 17:18:39 235 235 BOXCAR 4.1 2000/07/24 17:33:27 235 235 BINAVE 3.0 2000/07/24 17:34:36 235 48 REMOVECH 6.0 2004/03/26 13:53:18 48 48 HDREDIT2 1.9 2004/03/26 13:59:45 ? ? CLEAN 4.5 2004/03/26 14:00:10 48 48 CHANGE_CTD_CHANNEL_NAMES 1.0 2013/12/16 15:14:12 48 48 $END $REMARKS -The following DELETE parameters were used: Surface Record Removal: OFF Pressure NOT filtered Swells deleted. Warning message if pressure difference of 2.00 Drop rates< 0.25m/s (calculated over 6 points) will be deleted Sample interval = 0.50 seconds. -The following CALIB parameters were used: Calibration type = Raw Mode: ONLY - calibration specs from Cal File only. Pressure offset = 0.0 Calibration file = D:\9749\all\cnv146\calcond.ccl Calibrations applied: Ch Name Units Fmla Coefficents -- ----------------------------- --------- --- ----------------------------- 3 Conductivity:Primary ratio 10 0.0000000E+00 0.2330242E+00 -The following CALIB parameters were used: Calibration type = Raw Mode: ONLY - calibration specs from Cal File only. Pressure offset = 0.0 Calibration file = D:\9749\all\cnv1031\cal1031.ccf Calibrations applied: Ch Name Units Fmla Coefficents -- ----------------------------- --------- --- ----------------------------- 3 Conductivity:Primary ratio 10 0.0000000E+00 0.1000287E+01 -The following CLIP parameters were used. Clip by Channel Range Clip Channel: Pressure Min,Max = 4.000, 4000.000 Time Not Available in File -The following CHANNEL(S) were removed from file. Flag -The following DERIVEQ parameters were used Reference channel for pressure is: Pressure Reference channel for temperature is: Temperature:Primary Reference channel for conductivity ratio is: Conductivity:Primary Reference channel for salinity is: Salinity Computed properties Derived Properties Ref Press Temp Type Replace ------------------ --------- --------- ------- Salinity Insitu Insitu YES -The following CLIP parameters were used. Clip by Record Number Limits First Record,Last Record = 1,235 Time Not Available in File -The following FILTER parameters were used. Boxcar filter was used. Filter width = 7 The following channel(s) were filtered. Salinity -The following BINAVE parameters were used: Bin channel = Pressure Averaging interval = 1.0 Minimum bin value = 0.000 Bin value was used Interpolated values were NOT used for empty bins Channel 'NUMBER_OF_BIN_RECORDS' was added to file. -The following CHANNEL(S) were removed from file. Conductivity:Primary CLEAN functions: - Reset #RECS, MIN & MAX values in header. - Change Pad Value to -99 in All Channels. - Delete Empty Channels: 0 deleted. $END *COMMENTS SBE HEADER Sea-Bird SBE 19 Data File: FileName = 10jun16.HEX Software Version 4.026 Temperature SN = 1031 Conductivity SN = 1031 System UpLoad Time = Jun 10 1998 17:45:37 Cruise: SHEBA Station: 45 Latitude: 76 51.84 N Longitude: 166 3.84 W Depth: 1015 m (est) ds SEACAT PROFILER V3.0 SN 1031 06/11/98 00:36:22.744 strain gauge pressure sensor: S/N = 155452, range = 1000 psia, tc = 419 clk = 32767.516 iop = 182 vmain = 7.0 vlith = 5.7 mode = PROFILE ncasts = 18 sample rate = 1 scan every 0.5 seconds minimum raw conductivity frequency for pump turn on = 2926 hertz pump delay = 30 seconds samples = 34173 free = 23657 lwait = 0 msec SW1 = 80 battery cutoff = 5.8 volts number of voltages sampled = 2 logdata = NO S> cast 16 06/11 00:07:11 samples 32313 to 33591 sample rate = 1 scan every 0 .5 seconds stop = switch off # nquan = 4 # nvalues = 363 # units = metric # name 0 = pr: pressure [db] # name 1 = t090: temperature, ITS-90 [deg C] # name 2 = c0S/m: conductivity [S/m] # name 3 = flag: 0.000e+00 # span 0 = 0.561, 50.787 # span 1 = -1.6542, -1.1914 # span 2 = 2.490642, 2.584461 # span 3 = 0.000e+00, 0.000e+00 # interval = seconds: 0.5 # start_time = Jun 11 98 00:07:11 # bad_flag = -9.990e-29 # sensor 0 = Frequency 0 temperature, 1031, 15may97s # sensor 1 = Frequency 1 conductivity, 1031W, 15may97s, cpcor = -9.5700e-08 # sensor 2 = Extrnl Volt 0 transmissometer, 109, 10dec97 # sensor 3 = Pressure Voltage, 155452, 15may97 # datcnv_date = Jun 30 2000 15:09:06, 4.244 # datcnv_in = 980611-1.HEX 1031-97.CON # datcnv_skipover = 0 # alignctd_date = Jul 24 2000 11:57:41, 4.244 # alignctd_in = 97490045.CNV # alignctd_cond_advSecs = 0.000, 0.000 # alignctd_temp_advSecs = 0.700, 0.000 # alignctd_oxygen_current_advSecs = 0.000, 0.000 # alignctd_oxygen_temp_advSecs = 0.000, 0.000 # alignctd_wetstar_advSecs = 0.000 # file_type = ascii END* *CALIBRATION $TABLE: RAW CHANNELS ! Name Units Fmla Pad Coefficients ! ---------------------- ------- ---- ------ ------------ Conductivity:Primary ratio 10 -9.99 (0 0.2330242) Conductivity:Primary ratio 10 -9.99 (0 1.000287) $END !--1--- ---2---- ---3---- -4-- !Pressu Temperat Salinity Numb !re ure: er_o ! Primary ~bin ! _rec ! ords !------ -------- -------- ---- *END OF HEADER 4.0 -1.6525 31.2379 2 5.0 -1.6521 31.2371 5 6.0 -1.6523 31.2366 6 7.0 -1.6520 31.2369 6 8.0 -1.6507 31.2391 6 9.0 -1.6476 31.2452 6 10.0 -1.6465 31.2475 5 11.0 -1.6465 31.2477 6 12.0 -1.6463 31.2482 4 13.0 -1.6475 31.2495 5 14.0 -1.6466 31.2509 6 15.0 -1.6447 31.2560 5 16.0 -1.6402 31.2656 6 17.0 -1.6326 31.2797 4 18.0 -1.6270 31.2864 5 19.0 -1.6223 31.2924 6 20.0 -1.6095 31.3057 7 21.0 -1.5948 31.3218 4 22.0 -1.5859 31.3389 5 23.0 -1.5441 31.4255 8 24.0 -1.4807 31.5169 5 25.0 -1.4729 31.5581 4 26.0 -1.4345 31.6331 6 27.0 -1.4078 31.6824 6 28.0 -1.3980 31.7239 5 29.0 -1.3598 31.7941 4 30.0 -1.2713 31.8729 7 31.0 -1.2007 31.9166 5 32.0 -1.2005 31.9529 6 33.0 -1.2127 31.9784 6 34.0 -1.2404 31.9949 5 35.0 -1.2448 32.0091 4 36.0 -1.2635 32.0195 5 37.0 -1.2655 32.0377 5 38.0 -1.2915 32.0653 5 39.0 -1.3074 32.0791 3 40.0 -1.3191 32.0882 4 41.0 -1.3298 32.0933 2 42.0 -1.3341 32.0970 4 43.0 -1.3466 32.1061 3 44.0 -1.3644 32.1237 5 45.0 -1.3794 32.1440 4 46.0 -1.3866 32.1576 6 47.0 -1.3898 32.1720 4 48.0 -1.3888 32.1833 3 49.0 -1.3934 32.1989 4 50.0 -1.4028 32.2196 6 51.0 -1.4031 32.2288 2